Hi,
First off I want to thankyou for incorporating the ESP into the Arduino IDE!

I have a www.doit.am esp12e devkit module with the motor shield board.
it programs fine with the Arduino IDE. Board esp12e, 80mhz etc
So I tested it with the blink sketch and if I said blink pin 0 it would blink pin 3 on the board/chip.
So here is the other pins.
pin0 = pin3
pin1 = flashing led on the nodemcu
pin2 = pin4
pin3 = nothing
pin4 = pin2
pin5 = pin1
pin6 = nothing
pin7 = nothing
pin8 = nothing

Any ideas?
Do I need a different firmware. I have version 0.95_20150318

Cheers