Use busio after nativeio split.

Author: tannewt

adafruit_bus_device/i2c_device.py

@@ -25,7 +25,7 @@ class I2CDevice:
  Represents a single I2C device and manages locking the bus and the device
  address.
 
- :param ~nativeio.I2C i2c: The I2C bus the device is on
+ :param ~busio.I2C i2c: The I2C bus the device is on
  :param int device_address: The 7 bit device address
 
  .. note:: This class is **NOT** built into CircuitPython. See
@@ -35,11 +35,11 @@ class I2CDevice:
 
  .. code-block:: python
 
- import nativeio
+ import busio
  from board import *
  from adafruit_bus_device.i2c_device import I2CDevice
 
- with nativeio.I2C(SCL, SDA) as i2c:
+ with busio.I2C(SCL, SDA) as i2c:
  device = I2CDevice(i2c, 0x70)
  bytes_read = bytearray(4)
  with device:

adafruit_bus_device/spi_device.py

@@ -25,7 +25,7 @@ class SPIDevice:
  Represents a single SPI device and manages locking the bus and the device
  address.
 
- :param ~nativeio.SPI spi: The SPI bus the device is on
+ :param ~busio.SPI spi: The SPI bus the device is on
  :param ~microcontroller.Pin chip_select: The chip select pin
  :param int extra_clocks: The minimum number of clock cycles to cycle the bus after CS is high. (Used for SD cards.)
 
@@ -36,11 +36,11 @@ class SPIDevice:
 
  .. code-block:: python
 
- import nativeio
+ import busio
  from board import *
  from adafruit_bus_device.spi_device import I2CDevice
 
- with nativeio.SPI(SCK, MOSI, MISO) as spi_bus:
+ with busio.SPI(SCK, MOSI, MISO) as spi_bus:
  device = SPIDevice(spi_bus, D10)
  bytes_read = bytearray(4)
  with device as spi: