How to control an LED’s brightness using a potentiometer

Components Needed:

• Arduino (or any microcontroller with ADC + PWM).
• 10kΩ potentiometer.
• LED + 220Ω resistor (to limit current).
• Breadboard and jumper wires.

1. Circuit Wiring
Potentiometer:

• Connect one outer pin to 5V (Arduino's 5V pin).
• Connect the other outer pin to GND.
• Connect the wiper (middle pin) to analog input A0.

LED:

• Connect the anode (long leg) to a PWM-capable digital pin (e.g., D9).
• Connect the cathode (short leg) to GND via a 220Ω resistor. https://www.arduino.cc/wiki/static/8a9e50e3d2e5c1a3069b5e8a8c2e4d3e/5a190/potentiometer_led.png

2. Arduino Code

cpp const int potPin = A0; // Potentiometer connected to A0 const int ledPin = 9; // LED connected to PWM pin 9 void setup() { pinMode(ledPin, OUTPUT); // Set LED pin as output Serial.begin(9600); // Start serial monitor (optional) } void loop() { int potValue = analogRead(potPin); // Read pot (0–1023) int brightness = map(potValue, 0, 1023, 0, 255); // Map to PWM range (0–255) analogWrite(ledPin, brightness); // Set LED brightness // Optional: Print values to serial monitor Serial.print("Potentiometer: "); Serial.print(potValue); Serial.print(", Brightness: "); Serial.println(brightness); delay(50); } 

How It Works
1. Read Potentiometer:

analogRead(A0) reads the wiper voltage (0–1023 for 10-bit ADC).

2. Map to PWM Range:

map() converts 0–1023 → 0–255 (PWM range for analogWrite).

*3. Control LED Brightness:
*
analogWrite(9, brightness) sets the duty cycle (0=off, 255=full brightness).

3. Advanced Tweaks
A. Exponential Brightness (Better for Human Perception)
Human eyes perceive brightness logarithmically. Modify the map() line:

cpp int brightness = pow(potValue / 1023.0, 2.5) * 255; // Exponential curve 

B. Adding a Capacitor for Smoothing
To reduce flickering, add a 0.1µF capacitor between the pot’s wiper and GND.

C. Using an RGB LED
Control three PWM pins (red, green, blue) with three pots for color mixing!

4. Common Issues & Fixes
LED doesn’t dim:

Check if the LED is connected to a PWM-capable pin (marked with ~ on Arduino).

Values jump erratically:

Add a capacitor (0.1µF) or check for loose connections.

LED too bright/dim at extremes:

Adjust the map() range (e.g., map(potValue, 50, 1000, 10, 200)).

5. Extensions

• Motor Speed Control: Replace the LED with a motor driver (e.g., L298N).
• OLED Display: Show the potentiometer value on a screen.
• MIDI Controller: Use the pot to adjust software parameters (e.g., synth volume).